2. Transportation, Storage and Installation
2-16
TI 33Q01J10-01E
a
b
c
F020418.ai
Top plate
Bottom plate
Bottom plate of desk
M3 screws
Hooked part (3 places)
a
d
b
c
i
g
e
h
g
i
f
h
Figure Joining Parts and Tools for Interconnecting LPCKITs Side-by-Side
Referring to the figure above, follow the procedure described below to connect the HIS with bolts.
When tightening bolts e, f, and g, make sure that console type HIS are aligned.
1. Using a hexagonal wrench, loosen hex socket head bolts d (4 bolts) securing the main body
and the channel base to each other.
2. Remove the bottom place of desk, and tighten the tapered bolt screws e using an L-wrench
j. To remove the bottom place of desk, remove the four M3 screws holding it – then you can
slide the lower plate about 3 mm to the rear, lift the hooked part of the plate from the square
holes in the lower part of the operator keyboard, and remove the plate from the bottom.
3. Remove the top plates and tighten tapered bolt screws with L-wrench k.
4. Open front and rear doors, and tighten bolt screws g with an L-wrench j.
5. Confirm that surfaces of the side-by-side HIS are aligned, then use a hex wrench to join
main body to the channel base using hex bolts. If there’s a gap between main body and
channel base, insert liner.
6. Replace the removed plates and bottom plates in their original positions.
SEE
ALSO
For details on the related tools and parts for joining console-type HIS’s side-by-side, refer to “Tools and Parts
Required for Joining Console Type HIS side by side.”
IMPORTANT
Don’t pass wiring to non-Yokogawa equipment through the console type HIS.
However, the wiring of PC or UPS installed in the console type HIS (LPCKIT, YPCKIT) is
excluded.
Sep. 30, 2008-00