18
En
Connections
■
Connecting the speaker cable
1
Remove approximately 10 mm (0.4 in) of
insulation from the end of each speaker
cable and then twist the exposed wires of the
cable together to prevent short circuits.
2
Loosen the knob using the supplied speaker
terminal wrench.
3
Insert one bare wire into the hole on the side
of each terminal.
4
Tighten the knob to secure the wire using the
supplied speaker terminal wrench.
5
Hook the speaker terminal wrench onto
WRENCH HOLDER on the rear panel of this
unit when not in use.
■
Connecting to the SP2 speaker
terminals
Connect Zone 2 or Zone 3 speakers to these terminals (see
page 108).
1
Open the tab.
2
Insert one bare wire into the hole on the
terminal.
3
Close the tab to secure the wire.
10 mm (0.4 in)
Speaker terminal wrench
Red: positive (+)
Black: negative (–)
Red: positive (+)
Black: negative (–)
