Yamaha RX-V1800, Руководство пользователя

Страница: 112 / 841

110
En
Using multi-zone configuration
y
• You must complete this step within 10 seconds while the
selected zone flashes in the front panel display. Otherwise,
the currently selected zone mode is automatically
canceled. In this case, press
P
ZONE CONTROLS
again.
• The initial setting is ZONE2 when both Zone 2 and Zone 3
are turned on.
3
Refer to “Selecting the input source of Zone
2 or Zone 3”, “Adjusting the volume level of
Zone 2 or Zone 3”, “Adjusting the balance of
the speaker level in Zone 2 or Zone 3” or
“Adjusting the tonal quality of Zone 2 or
Zone 3” on page 111 to perform further
operations.
Remote control operations
1
Set the operation mode selector to
C
AMP
and then press
A
SELECT
k
repeatedly to
select the zone you want to control.
“ZONE 2” or “ZONE 3” is displayed in the display
window (
A
) on the remote control.
2
Refer to “Selecting the input source of Zone
2 or Zone 3”, “Adjusting the volume level of
Zone 2 or Zone 3”, “Adjusting the balance of
the speaker level in Zone 2 or Zone 3” or
“Adjusting the tonal quality of Zone 2 or
Zone 3” on page 111 to perform further
operations.
3
Press
A
SELECT
k
/
n
to exit from the
Zone 2/Zone 3 mode.
■
Turning on or off Zone 2 and/or Zone 3
using the remote control
8
POWER and
7
STANDBY on the remote control
work differently depending on the selected zone that
appears in the display window (
A
) on the remote control.
• When the main zone, Zone 2 or Zone 3 mode is
selected, you can turn on the main zone, Zone 2 or
Zone 3 or set them to the standby mode individually.
• When the all mode is selected, pressing
8
POWER
turns on the main zone, Zone 2 and Zone 3
simultaneously and pressing
7
STANDBY sets them
to the standby mode simultaneously.
• When the remote control is in the main zone mode, “MAIN”
appears for a few seconds when
8
POWER or
7
STANDBY
is pressed.
• “ALL” appears in the display window (
A
) on the remote
control only when
A
SELECT
n
is pressed.
SELECT
TV
SOURCE
AMP
or
Control mode
Display window
(
A
)
POWER
and
STANDBY
Main zone
mode
Name of the selected
input area
Turns on the main
zone only or sets it to
the standby mode.
Zone 2 mode
“ZONE 2” or “2;name
of the selected input
area” Turns on Zone 2 or
sets it to the standby
mode.
Zone 3 mode
“ZONE 3” or “3;name
of the selected input
area” Turns on Zone 3 or
sets it to the standby
mode.
All mode
“ALL”
8
POWER : turns on
the main zone, Zone
2 and Zone 3.
7
STANDBY
: sets
the main zone, Zone
2 and Zone 3 to the
standby mode.
Notes