34
While operating the portable node, the following functions may be set and operated on the portable node FTM-300D/
FTM-200D transceiver.
Function
Key or Dial
Return to the transceiver setting screen
Press and hold the
D X
key
Adjusts the squelch level
Press the
SQL
key, then rotate the A-Band
DIAL
knob (FTM-300D)
or the
DIAL
knob (FTM-200D)
Enters the BACKTRACK screen
Press the
DISP
key
Enters the Set mode*
Press and hold the
F
SETUP
key (FTM-300D),
Press and hold the
F
MENU
key (FTM-200D)
Displays the Function Menu Screen (FTM-300D)
Displays the Function List Screen (FTM-200D)
Press the
F
SETUP
key (FTM-300D),
Press the
F
MENU
key (FTM-200D)
Selects the Transmission Power Level
Function Menu
[
FUNCTION
]
[
TXPWR
] (FTM-300D),
Function List
[
TXPWR
] (FTM-200D),
or press the
P4
key on the microphone (by default setting)
Selects Speaker Mute
Press the
MUTE
key on the microphone
Turning the back light ON and OFF
Press and hold the
DISP
key
Disconnects a node or a room on the Internet
Press and hold the
*
key on the microphone
*Some items in the Set mode and Function menu are automatically set for the Portable Digital Node function, so the
settings cannot be used.
Setting the speaker mute
The audio output to the speaker of the node station FTM-300D/FTM-200D transceiver can be muted, it cannot be set
in Direct Operation.
Press the [
MUTE
] key on the microphone each time toggles the mute mode as follows.
MUTE OFF
MUTE ALL
MUTE TX
MUTE RX
MUTE OFF
・・・
MUTE OFF
: Disable mute.
MUTE ALL
: Mute both the received voice from the C4FM digital station and the voice from the node station on the
Internet.
MUTE RX
:
Mute the received voice from the C4FM digital station.
MUTE TX
:
Mute the voice from the node station on the Internet.
FTM-100D
1. Press the [
D X
] key on the portable node FTM-100D transceiver.
The “
X
” icon flashes on the LCD screen.
• The display screen example uses the “
Access Point
” screen. In “
Direct Operation
”,
“
DIRECT
” is displayed instead of frequency
• If the “
X
” icon does not blink when the [
D X
] key is pressed, communication between the
transceiver connected to the PC and the WIRES-X software has not been established, so
check the cable connection and USB driver installation.
• To cancel the connection, press and hold the [
D X
] key.
2. When the operation of the portable node is started, the “
X
” icon changes from blinking
to lit and the Node ID and the city of its own station are displayed.
Depending on the history of the previously connected node on the internet and the
current connection status of the portable node, one of the following four screens is
displayed.
If the portable node is not connected to a node or a room on the Internet
①
When connection history is not stored
The connection destination display will be blank.
②
When connection history is stored
The ID of the previously connected ID will blink.
Press the
PTT
switch to connect to the previously connected ID.
