Yaesu VX-3R, Руководство по эксплуатации, Страница: 72 / 132

VX-3R O
PERATING
M
ANUAL
70
The
VX-3R
provides a message feature, which sends a message (up to 16 characters)
instead of sending a voice. 20 different messages can be programmed, and one of them can
be selected and transmitted with your ID.
Note
ˆ
The Message Feature requires that all members (1) use the
VX-3R
or Vertex
Standard
FTM-10R
transceiver, (2) store the same messages into the mes-
sage slot, (3) store the same member list into the member box, and (4) set the
same frequency.
ˆ Does not send the Message through the repeater.
P
ROGRAMMING A
M
ESSAGE
(Requires all members set the same message into the same message slot in the same order.)
The VX-3R has 20 message slots, including a factory-programmed message (EMER-
GENCY). The factory-programmed message of course can be overwritten at any time with
personalized messages.
1. Press and hold in the [ TXPO
] key for one second to enter the Set mode.
2. Rotate the DIAL knob to select Set Mode Item 57:
MSG.SEL MSG.SEL MSG.SEL MSG.SEL MSG.SEL
.
Note : Do not forget to pull the DIAL knob to rotate the DIAL
knob.
3. Press the [ TXPO
] key momentarily to enable adjustment of this
Set Mode Item.
4. Rotate the
DIAL
knob to select the desired Message slot into
which you wish to store a message. The LCD displays the previ-
ously stored message.
5. Press the [
V/M
] key momentarily to enable programming of the
message.
6. Press and hold in the [ HM/RV
] key for one second to clear the
previously stored message, if desired.
7. Rotate the DIAL knob to select the first character of the message
you wish to store, and then press the [ V/M
] key to save the first
character of the message and move on to the next place.
8. Repeat the previous step to complete the message (up to 16 char-
acters). If you make a mistake, press the [ BAND
] key to move
back to the incorrect character, then re-enter the correct character.
9. Press the [ HM/RV
] key to delete all data after the cursor that
may have been previously stored erroneously.
10. When the Message entry is complete, press the [
TXPO
] key momentarily.
11. If you wish to store another message, repeat steps 3 through 10 above.
12. Press the
PTT switch to exit to normal operation.
M
ESSAGE
F
EATURE