Yaesu FT DX 9000MP CONTEST - DATA MANAGEMENT OPERATION, Руководство по эксплуатации

Страница: 119 / 180

Page 117 FT
DX
9000MP O
PERATION
M
ANUAL
CW C CW C
CW C CW C
CW C
ONVENIENCE ONVENIENCE
ONVENIENCE ONVENIENCE ONVENIENCE
F F F F F
EA EA
EA EA EATURES
TURES
TURES TURES TURES
Message Memory Programming (Using Your Paddle)
1. Press the [ CW
] Mode key to set the operating mode
to CW.
2. Set the [
BK-IN/SPOT
] switch to Off.
3. Turn the internal Electronic Keyer On by pressing the
[
KEYER
] switch, if necessary.
4. Press the FH-2 ’s [ MEM
] key.
C
ONTEST
M
EMORY
K
EYER
5. Press the [ 1
] ~ [
2
] key on the
FH-2 to begin the
memory storage process.
6. Send the desired message using your keyer paddle.
7. Press the [
MEM
] key on the
FH-2 once more at the
end of your message. Up to 50 characters may be
stored among the five memories.
N N N N N
O O O O OTE TE TE TE TE
:
You must exercise care in sending to ensure that the spaces
between letters and words are accurately done; if your tim-
ing is off, the spacing may not come out right in the stored
message.
For ease in setting up the keyer memories, we recommend
you set Menu item “
MODE-CW 049 F-KEYER TYPE ”
(KEYER FRONT) and/or “ MODE-CW 051 R-KEYER
TYPE ” (KEYER REAR) to “ACS” (Automatic Character
Spacing) while you are programming the keyer memories.
Checking the CW Memory Contents
1. Be sure that Break-in is still turned Off.
2. Press the
FH-2 ’s [ 1
] ~ [
5
] key to check your work.
You will hear the results in the sidetone, but no RF
energy will be transmitted.
On-The-Air CW Message Playback
1. Press the [ BK-IN/SPOT
] key to enable transmission.
Either Full- or Semi-break-in will be engaged, depend-
ing on the setting of Menu item “
MODE-CW 055
CW BK-IN ”.
2. Press the FH-2 ’s [ 1
] ~ [
5
] key to transmit the pro-
grammed message.
N N
N N
N
O O O O OTE TE TE TE TE
:
If you subsequently decide to use the “Text” technique
for memory storage, please note that the contents of a
message stored using keyer paddle input will not be
transferred over when you select “TEXT” on a par-
ticular memory register.
LOCK
OFF ON
LOCK
OFF ON
LOCK
OFF ON
LOCK
OFF ON
Transmitting in the Beacon Mode
It is possible to transmit, repetitively in a “Beacon” mode, any message programmed either via paddle input or via the
“Text” input method. The time delay between message repeats may be set anywhere between 0 and 255 seconds via
Menu item “
FH-2 SET 024 BEACON TIME ”. If you do not wish the message to repeat in a “Beacon” mode, please
set this Menu item to “Off.”
Press the [
1
] ~ [
5
] key, depending on the register into which the Beacon message is stored. Repetitive transmission of
the Beacon message will begin. Press one of these keys once more to halt the Beacon transmissions.