Yaesu FT DX 9000MP CONTEST - DATA MANAGEMENT OPERATION, Руководство по эксплуатации

Страница: 166 / 180

Page 164 FT
DX
9000MP O
PERATION
M
ANUAL
NNNNN
OOOOOTE TE
TE TE TE
TX GNRL G
ROUP
173. TX MAX POWER
Function : Selects a maximum output power limit.
Available Values : 400/200/100/50 W
Default Setting : 400 W
174. TX PWR CONTROL
Function : Configures the RF PWR knob.
Available Values : ALL MODE/CARRIER
Default Setting : ALL MODE
ALL MODE: The [ RF PWR
] knob is enabled on all
modes.
CARRIER: The [ RF PWR
] knob is enabled in all
modes except SSB. In this configura-
tion, the SSB output power will be set to
maximum, regardless of the [
RF PWR
]
knob’s position.
175. EXT AMP TX-GND
Function : Enables/Disables the TX GND jack on the
rear panel.
Available Values : ENABLE/DISABLE
Default Setting : DISABLE
176. EXT AMP TUNING PWR
Function : Selects a maximum output power limit for
driving the input circuit of an external linear RF am-
plifier while tuning (while using the Remote Control
function of the linear RF amplifier).
Available Values : 400/200/100/50 W
Default Setting : 100 W
177. FULL DUPLEX
Function : Enables/Disables Full Duplex operation.
Available Values : SIMP/DUP
Default Setting : SIMP
When this menu is set to “DUP,” you may receive on
the sub band (VFO-B) frequency while transmitting,
during dual receive operation, on a different band on
the main band (VFO-A).
178. VOX SELECT
Function : Selects the audio input source for trigger-
ing TX during VOX operation.
Available Values : MIC/DATA
Default Setting : MIC
MIC: The VOX function will be activated by micro-
phone audio input.
DATA: The VOX function will be activated by data
audio input.
179. EMERGENCY FREQ TX
Function : Enables Tx/Rx operation on the Alaska
Emergency Channel, 5167.5 kHz.
Available Values : DISABLE/ENABLE
Default Setting : DISABLE
When this Menu Item is set to “ENABLE,” the spot
frequency of 5167.5 kHz will be enabled. The Alaska
Emergency Channel will be found between the
Memory channels “P-1” and “01 (or 1-01).”