Yaesu FT DX 9000MP CONTEST - DATA MANAGEMENT OPERATION, Руководство по эксплуатации

Страница: 45 / 180

Page 43 FT
DX
9000MP O
PERATION
M
ANUAL
BBBBB
ASIC ASIC
ASIC ASIC
ASIC
O O O O O
PERA PERA
PERA PERA
PERATION TION
TION TION
TION
::::: R R R R R
ECEIVING ECEIVING
ECEIVING ECEIVING
ECEIVING ON ON
ON ON
ON
AAAAA
MA MA
MA MA
MATEUR TEUR
TEUR TEUR
TEUR
B B B B B
ANDS ANDS
ANDS ANDS
ANDS
Before turning on main power, please verify the following items once more.
y Have you made all ground connections securely? See page 14 for details.
y Do you have your antenna(s) connected to the rear-panel Antenna jack(s)? See page 14 for details.
y Is your microphone (and/or key or paddle) connected? See page 15 and 16 for details.
y If using a linear amplifier, have all interconnections been successfully completed? See page 17 and 18 for details.
y Please rotate both [ AF GAIN
] controls to their fully counter-clockwise positions, to avoid a loud blast of audio when
the transceiver turns on. See page 29 and 32 for details.
y Rotate the [ RF PWR
] control fully counter-clockwise, to set minimum power at first. See page 29 for details.
y When first using the transceiver on a voice mode, you must tell it which microphone jack you wish to use (by default, the
front panel’s “Cannon” (XLR) connector is connected, and the rear panel’s 8-pin round mic jack is not connected. You
may use Menu “
MODE-SSB 077 SSB MIC SELECT ” to set the desired microphone jack for the LSB and USB
modes. Similarly, use Menu “ MODE-AM 048 AM MIC SELECT ” for the AM mode, and Menu “ MODE-FM 066
FM MIC SELECT ” for the FM mode.
N N N N N
O O O O OTE TE TE TE TE
:
If the wrong microphone jack is selected, voice transmission will not be possible.
y Once AC power is applied, please refer to the “Data Manegement Operation Manual” and perform the setup for the
Local Time. If this setup procedure is not performed, the World Clock and Logbook functions will not operate correctly.
y If your AC mains power should suffer a significant fluctuation or interruption, we recommend that you go through a
complete power-up cycle, in order to ensure that all circuits are properly initialized. To do this, be sure the front panel
Power switch is turned off, then set the
FPS-9000H ’s Power switch to the “
O
” position. Now unplug the AC cable from
the AC line, and wait ten seconds. The start-up procedure is described on the next page.