Yaesu FT DX 9000MP CONTEST - DATA MANAGEMENT OPERATION, Руководство по эксплуатации

Страница: 113 / 180

Page 111 FT
DX
9000MP O
PERATION
M
ANUAL
CW M CW M
CW M CW M
CW M
ODE ODE
ODE ODE ODE
O O O O O
PERA PERA
PERA PERA PERATION
TION
TION TION TION
U
SING THE
B
UILT
-
IN
E
LECTRONIC
K
EYER
A number of interesting and useful features are available during Electronic Keyer operation.
Morse
"E" & "T"
Morse
"E" & "T"
ACS
OFF
Space
ACS
ON
[Main Tuning Dial] Knob
VDD TEMP SWR BIAS
Setting the Keyer Weight (Dot/Space:Dash ) Ratio
The Menu may be used to adjust the Weight for the built-in Electronic Keyer. The default weighting is 3:1 (a dash
is three times longer than a dot or space).
1. Press the [ MNU
] key to enter the Menu mode.
2. Rotate the [ MAIN Tuning Dial
] knob to select Menu item “
MODE-CW 057 CW WEIGHT ”.
3. Rotate the [ CLAR/VFO-B
] key to set the weight to the desired value. The available adjustment range is for a
Dot/Space:Dash ratio of 2.5 ~ 4.5 (default value: 3.0).
4. When you are finished, press and hold in the [ MNU
] key for two seconds to save the new setting and exit to
normal operation.
Selecting the Keyer Operating Mode
The configuration of the Electronic Keyer may be customized independently for the front and rear [ KEY
] jacks of
the FT
DX
9000MP . This permits utilization of Automatic Character Spacing (ACS), if desired, as well as the use
of the electronic keyer via the front jack and a straight key or computer-driven keying line via the rear panel.
1. Press the [
MNU ] key to enter the Menu mode.
2. Rotate the [ MAIN Tuning Dial
] knob to select Menu item “
MODE-CW 049 F-KEYER TYPE ” (for the
front [ KEY
] jack) or “
MODE-CW 051 R-KEYER TYPE ” (for the rear-panel’s [ KEY
] jack).
3. Rotate the [ CLAR/VFO-B
] knob to set the keyer to the desired mode. The available selections are:
OFF : The built-in Electronic Keyer is turned off
(“straight key” mode.)
BUG : Dots will be generated automatically by
the keyer, but dashes must be sent manu-
ally.
ELEKEY : Both dots and dashes will be generated
automatically when you use your paddle.
ACS : Same as “ELEKEY” except that the spac-
ing between characters is precisely set by
the keyer to be the same length as a dash
(three dots in length.)
4. When you are finished, press and hold in the [ MNU
] key for two seconds to save the new setting and exit to
normal operation.
[MNU] Switch
[CLAR/VFO-B] Knob