Yaesu FT DX 9000MP CONTEST - DATA MANAGEMENT OPERATION, Руководство по эксплуатации

Страница: 137 / 180

Page 135 FT
DX
9000MP O
PERATION
M
ANUAL
You may scan wither the VFO or the memories of the FT
DX
9000MP , and the radio will halt the scan on any station with
a signal strong enough to open the receiver’s squelch.
VFO S
CANNING
1. Press the [ A
] or [
B
] switch to select the VFO to be
scanned.
2. Set the VFO to the frequency on which you would
like to begin scanning.
3. Rotate the [ SQL
] control (for Main (VFO-A) band
scan, for Sub (VFO-B) band scan) so that the back-
ground noise is just silenced.
4. Press and hold in the microphone’s [ UP
] or [
DOWN
]
key for 2 second to start scanning in the specified di-
rection.
[CLAR/VFO-B] Knob
VDD TEMP SWR BIAS
[V/M] Switch
If the scanner halts on an incoming signal, the decimal
point between the “MHz” and “kHz” digits of the fre-
quency display will blink.
If the incoming signal disappears, scanning will resume
in about five seconds.
On the SSB/CW and SSB-based Data modes, the scan-
ner will pause on a received signal, then will step across
the signal very slowly, giving you time to stop the scan,
if you like. In these modes on the VFO, the scanner
does not stop, however.
VFO VFO
VFO VFO
VFO
AND AND
AND AND AND
M M M M M
EMOR EMOR
EMOR EMOR EMORYYYYY
S S S S S
CANNING CANNING
CANNING CANNING CANNING