Y3K XDVR2, Руководство пользователя

Страница: 79 / 124

User’s Manual
78
5.3.6 Termination >
This item is used to enable / disable the 75-termination resistor inside the unit
to adjust the image quality of each camera. <YES>= termination resistor
enabled (default), <NO> = termination resistor disabled.
NOTE: If the camera loop-out connectors have not been used, the
termination resistor should be enabled for appropriate signal
termination.
5.3.7 Brightness >
Move the cursor to the item and press ENTER for adjusting the brightness of
the camera. Use UP / DOWN keys to adjust the numeric value. The range of
brightness values is <-128> to <127>. The default setting is <0>.
5.3.8 Contrast >
Move the cursor to the item and press ENTER for adjusting the contrast of the
camera. Use UP / DOWN keys to adjust the value.
5.3.9 Saturation >
Move the cursor to the item and press ENTER to adjust the color saturation of
the camera using UP / DOWN keys. This value will be ignored on
monochrome monitors. The range of saturation values is <-128> to <127>.
The default setting is <0>.
5.3.10 Hue >
Move the cursor to the item and press ENTER for adjusting the hue of the
camera. Use UP / DOWN keys to adjust the value.
5.3.11 Audio Association >
The item is used to establish the connection between the selected camera
and the two audio-in channels. Move the cursor to <Audio Association> in
Camera Setup menu and press ENTER, then select <Both>, <Left Only>,
<Right Only> or <None> by UP / DOWN keys to set up the connection.