User’s Manual
34
NOTE:
Once the VGA monitor is now under Dome Control Mode or the
OSD setup mode, or hasn’t exit the OSD menu, the BNC monitor is
unable to access the OSD setup menu.
4.2
Sequence Setup
This section introduce you how to view in sequence mode with both Main
Monitor and Call Monitor, if connected. Sequence function can avoid manually
backtracking and give more flexibility while surveillance.
4.2.1
Sequence with Main Monitor
Automatic sequence function can be used in any view mode. Select certain
view format and press SEQ to toggle the automatic sequential sequence,
press ESC to stop sequencing. The figure below displays the 4-camera
sequencing view modes.
4.2.2
Sequence with Call Monitor
Users are allowed to use the
XDVR2
unit front panel to control a call monitor
display without having to access the Main menu. Two viewing modes can be
displayed on call monitor: Sequence display and Single camera display. To
program the call monitor sequence, see Section 5.5 Sequence Setup.
Follow the steps to control the call monitor.
•
Press the CALL key on the front panel to enter call monitor control mode,
the message “Call Mode” will be shown on the bottom-left of the screen.
Press 1-16 Key To Select Channel
Press SEQ To Enable Sequence
Call Mode
•
Press CHANNEL key to display the associated camera on call monitor.
Содержание XDVR2
