Xerox QLS-8100XE, Инструкция по эксплуатации и установке

Страница: 37 / 185

QLS-8100 Xe 3-5
3 Flip the Drive Roller Lift Lever clockwise to open the drive roller.
4 Remove the Media Retainer from the media supply mandrel by first
loosening the small nylon retaining screw then sliding the Media
Retainer away from the printer and off the mandrel.
5 Orient the roll so that the labels are coming off the top and to the right.
Using the media retainer to push the roll, slide the roll onto the mandrel
until it is firmly seated against the back plate. You will feel resistance as
the spring clip on the mandrel secures the roll.
Note: If the media is not fully seated against the back plate, an unprinted
vertical area or void will appear on the printed label.
6 Ensure that the Media Retainer is firmly against the media roll and hand-
tighten the nylon retaining screw to secure the Media Retainer to the
mandrel.
7 Lift the Media Dancer Arm to the right and upwards to relieve back-
tension on the media supply roll. Unroll approximately a 3-foot length of
media.
8 Thread the media down and to the left, then around the Media Dancer
Arm.
9 Remove the Media Guide Collar from the lower Media Guide Roller.
10 Continue to thread the media over and around the Upper Media Guide
Roller then under and around the Lower Media Guide Roller.
11 Thread the media through the Media Sensor Assembly and then through
the Media Travel Roller assembly.