Xcel-Arc RazorWeld Razor TIG320 ACDC, Руководство по эксплуатации

Страница: 26 / 56

26
1. Connect the Tig Torch connector to the negative terminal and tighten it.
2. Insert the torch gas connector into the quick lock gas receptacle.
3. Connect the torch switch remote lead into the torch remote socket.
4. Connect the torch water leads connectors into the quick lock gas receptacles.
5. Connect the Earth Cable connector into the positive terminal and tighten it.
6. Turn on the Water Cooler with the on/off switch on the front panel of the Water Cooler.
7. Connect gas line to Gas Regulator, connect the gas regulator to the Gas Cylinder, open the cylinder valve slowly.
8. Connect the gas line to the quick lock gas inlet connector at the rear of the machine.
Check for gas leaks -
Esseti NZ Ltd nor it's representatives will be responsible for any gas loss.
9. Switch on the machine using the On/Off switch at the rear of the machine.
10. Set the weld parameters using the front panel set procedure on the following page.
Installation Set Up for DC TIG Welding:
DC HF TIG Welding Setup and Operation
Razor
32OAC/DC TIG-MMA
7.
Connect the regulator to the cylinder,
Connect the gas lead to the regulator.
Set the flow to 8-12 l/min
3. Connect the torch switch lead
to the torch remote receptacle
1. Connect the TIG torch to the
terminal.
2. Insert the torch gas lead connector
into the quick lock gas receptacle.
8.
Connect the gas line to the quick lock
connector at the rear of the machine
10.
Set the weld parameters. See next
page for setup procedure
9. Turn on the Power source
using the on/off switch at
the rear of the machine
5. Connect the EARTH lead to
the terminal.
4. Insert the torch water leads connectors
into the quick lock gas receptacles.
6. Turn on the Water Cooler
using the on/off switch on
the front of the Water Cooler