Xcel-Arc RazorWeld Razor TIG320 ACDC, Руководство по эксплуатации

Страница: 21 / 56

21
Job Select, Job Save, Job Recall, Job Delete - Gas Test
Razor
32OAC/DC TIG-MMA
Allows the operator to save the set welding parameters and asign them to a
JOB number. The JOB number can be recalled later as required, the welding
parameters are preserved inside the JOB number ready for use.
The welding parameters stored inside the JOB number can be DELETED as
required.
JOB SELECT - JOB SAVE - JOB RECALL - JOB DELETE
11. JOB Select -
Allows the operator to enter the welding parameter storage mode and select the JOB number required.
JOB select: Select the JOB
number by pushing the JOB
select button and the
Gas Test button Reverse JOB select: To travel back
through the JOB list . Press the Gas
Test button. (
This button has dual function
)
Forward JOB Select: To cycle forwards
through the JOB numbers. Push the JOB
select button
The JOB number will show on the
digital display.
JOB save select: Select a JOB number. Press
the JOB select button & the Gas Test button
to select a JOB number.
12. JOB SAVE -
Allows the operator to enter set welding parameters and SAVE the data to a selected JOB number.
JOB save: Set welding parameters as
required. To save to the selected JOB
number press the JOB SAVE button JOB number: The selected
JOB number will show on the
digital display.
JOB
SAVE
JOB recall select: Select a JOB number.Press
the JOB select button & the Gas Test button
to select a JOB number.
(
This button has dual function
)
13. JOB RECALL -
Allows the operator to recall welding parameters saved to a JOB number.
JOB recall: Press the JOB RECALL button.
The saved welding parameters will be re-
called and appear on the front panel display. JOB number: The selected
JOB number will show on the
digital display.
JOB recall select: Select a JOB number.Press
the JOB select button & the Gas Test button
to select a JOB number.
13. JOB DELETE -
Allows the operator to recall welding parameters saved to a JOB number and DELETE the data saved.
JOB recall: Press the JOB DELETE button
and hold for 2 seconds..
The saved welding parameters will be de-
leted from the slected JOB number. JOB number: The selected
JOB number will show on the
digital display.
13. GAS TEST -
Allows the operator to test and set the Gas Flow prior to welding.
GAS TEST - Press the GAS TEST button and the gas will Flow, press the button again and the gas will
stop. The Gas Flow will time out after 20 seconds and stop if the Gas Test button is not re-pressed.
IMPORTANT NOTE - The GAS TEST button also serves as the Minus Cycle button function when in JOB SELECT mode