PH: 866.476.9217
14
V. OPENING CAR GATES
1.
Using the Rolling Carriage, roll the
GO-E2
Opener along the W-Beam until
you "rough spot" position the Gear Motor's output shaft with the hopper car
gate.
2.
Once in position use the T-Handle set screws to secure the Gear Motor and
Rolling Carriage in place.
3.
Disengage the Car Gate locking mechanism before attempting to open the
gate.
4.
Using the Capstan Swage Tool (optional accessory PN: 33-11120), clean-out
and square-up the Capstan Socket on the Car Gate so that the Capstan Drive
Fitting on the GO-E2 Opener's Driveshaft can be properly and fully seated in
the car's Capstan Socket when opening the gate.
5.
Extend and adjust the Telescoping Driveshaft until the Capstan Drive Fitting
on the yoke and tube assembly is firmly seated in the car's Capstan Socket.
6.
Position yourself away from the Drive Shaft so that fingers, tools or articles of
clothing do not get caught during operation.
7.
Press the "Forward" or "Reverse" momentary contact Pushbutton to open the
gate. If the gate is stuck, alternately press the "Forward" and "Reverse"
buttons to rock or jog the gate loose.
The Gear Motor must be securely fastened to its
foundation, and the rolling carriage must be
locked down before operating the GO-E2
Opener.
CAUTION
Failure to disengage the Car Gate locking
mechanism will cause damage to the Car Gate.
Содержание GO-E2
