WORKMASTER GO-E2, Руководство оператора

Страница: 17 / 40

PH: 866.476.9217 16
VI. CLOSING CAR GATES
1. Using the Rolling Carriage, roll the GO-E2 Opener along the W-Beam until
you "rough spot" position the Gear Motor's output shaft with the hopper car
gate.
2. Using the Capstan Swage Tool (optional accessory PN: 33-11120), clean-out
and square-up the Capstan Socket on the Car Gate so that the Capstan Drive
Fitting on the
GO-E2 Opener's Driveshaft can be properly and fully seated in
the car's Capstan Socket when closing the gate.
3. Disengage the Car Gate locking mechanism before attempting to close the
gate.
4. Extend and adjust the Telescoping Driveshaft until the Capstan Drive Fitting
on the yoke and tube assembly is firmly seated in the car's Capstan Socket.
5. Press the "Forward" or "Reverse" momentary contact Pushbutton to close the
gate. If the gate is stuck, alternately press the "Forward" and "Reverse"
buttons to rock or jog the gate loose.
6. Position yourself away from the Drive Shaft so that fingers, tools or articles of
clothing do not get caught during operation.
The Gear Motor must be securely fastened to its
foundation, and the rolling carriage must be
locked down before operating the GO-E2
Opener.
CAUTION
Failure to disengage the Car Gate locking
mechanism will cause damage to the Car Gate.
CAUTION
Do not hold either Pushbutton down for more
than a few seconds. Prolonged hold-down of
either button can cause the Gear Motor to
overheat and stall.