WORKMASTER GO-E2, Руководство оператора

Страница: 21 / 40

PH: 866.476.9217 20
IX. MAINTAINING THE GO-E2 OPENER
Operating any equipment, including the
GO-E2 Opener, until it ceases to run can be
very costly in terms of repairs and downtime. When the equipment finally breaks down,
usually more expensive parts are worn out or broken. In addition, it seems that
equipment always fails when it is most needed in production.
It is much wiser to develop a preventive maintenance program with an established
schedule for inspecting and servicing the GO-E2 Opener at regular intervals. The
length of these intervals will be determined by specific operating conditions.
We urge you to adhere to the following maintenance schedule guidelines:
Know and understand Lockout/Tagout Procedures as defined by American National
Standards Institute (ANSI) z244.1-1992. American National Standard for Personnel
Protection - Lockout/Tagout of Energy Sources - Minimum Safety Requirements, and
Occupational Safety Health Administration (OSHA) Federal Register, Part IV, 29CFR Part
1910, Control of Hazardous Energy Source (Lockout/Tagout); Final Rule, and as
amended.
Maintenance of the GO-E2 Gear Motor can be
performed only when electrical system is locked
out/tagged out.
IMPORTANT
Safety must be considered a basic factor in
machinery maintenance at all times.