Woodway 4Front, Руководство по обслуживанию

Страница: 50 / 97

50 05/2016 – SM-MT-EN-02
Standard screwdriver
Phillips head screwdriver
Save all removed hardware for installation of replacement parts. Perform the following
steps in order to properly remove the motor controller:
1.
Unplug the treadmill from the power source. Ensure that it cannot be turned back
on.
2. Identify the side of the treadmill with the AC power cord coming out of it (right side
running direction).
3. Remove the trim plate/boot screws (Pos. 1).
4. Slide the trim plate/boot up the handrail and out of the way (Pos. 2).
5. Remove the 2 screws holding the side cover down and remove the side cover
(Pos. 3, 4).
6. Remove the 6 screws holding the electrical cover to the frame and remove the elec-
trical cover (Pos. 5, 6).
7. Carefully, disconnect the wires connected to the motor control board, P1, P2, and
motor power wires (Pos. 9, 10, 11).
8. Remove the 4 screws holding the motor control board to the frame and remove the
motor control board (Pos. 7, 8).
Perform the following steps in order to properly reinstall the motor controller:
1. Using either standard/Phillips screwdriver, attach the four #8 (32 x ½”) Phillips pan
head machine screws and four #8 internal tooth lock washers that attach the motor
control board (Pos. 7, 8).
2. Carefully, attach the connectors that plug into the motor control board
(Pos. 10, 11).
3. Check calibration of the motor control board.
4. Re-install the electrical cover and 6 screws attaching it to the frame (Pos. 5, 6).
5. Re-install the side cover and 2 screws attaching it to the frame (Pos. 3, 4).
6. Re-install the trim plate/boot and 4 screws. Tighten the screws until they are just
touching the rubber boot (Pos. 1, 2).
Tools Needed
Removal
Installation