Woodway 4Front, Руководство по обслуживанию

Страница: 60 / 97

60 05/2016 – SM-MT-EN-02
1. Unplug the treadmill from the power source. Ensure it cannot be turned back on.
2. Remove the side covers from the treadmill (see Section 6.10).
3. Remove the handrail assembly from the frame (see Section 6.10).
4. Remove the running belt (see Section 6.15).
5. Using the ½” socket, loosen the motor mounting bolts and slide the belt forwards
until there is slack (Pos. 4, 5).
6. Remove the drive belt (Pos. 3).
7. Using the 9/16” box wrench, loosen the drive shaft bearing nuts and slide the drive
shaft off (Pos. 1, 2).
1. Place the new drive shaft on the treadmill and push it as far forward as it will go.
Make sure the Zerk fittings on the bearings are pointed out and accessible
(Pos. 1, 6).
2. Tighten the drive shaft bearing nuts and loosen the set screws on both bearings
(Pos. 2).
3. Align the drive shaft so that it is centered on the treadmill.
4. Apply red Loctite to the set screws and tighten them to 78 in-lbs.
5. Place the drive belt back on the motor and tension the drive belt to ¼” play
(Pos. 3, 4, 6).
6. Using the grease gun, apply a small amount of grease to the teeth of the drive
shaft. Do not over-grease, as this can cause build-up and collect dust.
7. Re-install the running belt (see Section 6.15).
8. Re-install the handrail assembly (see Section 6.10).
9. Re-install the treadmill side covers (see Section 6.10).
Removal
Installation