Woodway 4Front, Руководство по обслуживанию

Страница: 52 / 97

52 05/2016 – SM-MT-EN-02
Perform the following steps in order to properly reinstall the interface board:
1. Using either the standard/Phillips head screwdriver, attach the four #6 (32 x ¼”)
Phillips pan head machine screws and four #6 internal tooth lock washers that hold
down the interface board.
2. Carefully, attach the connectors that plug into the interface board. Keep the wires
clear of the elevation cam.
3. Install the electrical cover (if applicable) and 6 screws attaching it to the frame.
4. Re-attach the side cover and 2 screws to secure the cover to the frame.
5. Install the trim plate/boot and 4 screws. Tighten the screws until they are just
touching the rubber boot.
6.7 Speed/Incline Control Replacement
Save all removed hardware for installation of replacement parts
Fig. 52 Speed/incline control replacement
1. Switch
2. Switch nut
Standard screwdriver, small
Nut driver, ¼”
Perform the following steps in order to properly remove the speed/incline control:
1. Unplug the treadmill from the power source. Ensure it cannot be turned back on.
2. Remove 2 small nuts from the underside of the handrail (Pos. 2).
3. Using the small standard screwdriver, carefully pry up the edges of the assembly
and push upwards on the 2 screws sticking out of the bottom to release the adhe-
sive overlay (Pos. 1).
4. Unplug the cable.
Perform the following steps in order to properly reinstall the speed/incline control:
1. Plug the cable into the new switch (Pos. 1).
2. Remove the paper backing from the switch.
3. Guide the screws through the back side of the handrail and press the edges down
firmly to seal the switch assembly to the recessed area.
4. Re-install the 2 nuts on the underside of the handrail (Pos. 2).
Installation
Tools Needed
Removal
Installation