Woodway 4Front, Руководство по обслуживанию

Страница: 51 / 97

05/2016 – SM-MT-EN-02 51
6.6 Interface Board Replacement
Fig. 51 Interface board replacement
1. Interface board
2. Interface board screws
3. J1 connector
4. J2 connector
5. J3 connector
6. J5 connector
7. J6 connector
8. J10 connector
9. J9 RS-232 port
Standard screwdriver
Phillips head screwdriver
Perform the following steps in order to properly remove the interface board:
1. Unplug treadmill from the power source. Ensure it cannot be turned back on.
2. Identify the side of the treadmill with the AC power cord coming out of it (right
side running direction).
3. Remove the trim plate/boot screws.
4. Slide the trim plate/boot up the handrail and out of the way.
5. Remove the 2 screws holding the side cover down and remove the side cover.
6. If the treadmill is equipped with an electrical cover, remove the 6 screws holding
the electrical cover in place and remove the electrical cover.
7. Carefully, remove the connectors that plug into the interface board and label ac-
cordingly (e.g. J1, J2, etc.).
8. Using either the standard/Phillips head screwdriver, remove the four #6 (32 x ¼”)
Phillips pan head machine screws that hold down the interface board.
Tools Needed
Removal