Wood Stone FIRE DECK 6045, Руководство по обслуживанию

Страница: 10 / 44

PG
10
OF 44
M0011.09 APRIL 2019
Fire Deck
Service Manual
GAS OVEN COMPONENTS
GAS OVEN COMPONENTS
The following is a list of the key electrical and gas components found in Wood Stone gas ovens, accompanied by information about the
individual parts�
24 VOLT CLASS 2 TRANSFORMER
This Transformer incorporates a circuit breaker on its output� This unit is installed inside
a Junction Box on the left side of the Transformer Plate� Incoming power is connected to
the terminal strip (marked L, N, and G) inside this box� L=Line, N=Neutral, G=Ground�
24 VAC output can be measured in the adjacent junction box� 24 VAC should be present
between terminal P (pink wire) and terminal 8 (white wire)�
TRANSFORMER PLATE ASSEMBLY (PRIOR TO MAY 2015)
The Transformer Plate is located beneath the oven on the back stand� It consists of
one of the two types of transformers and a Junction Box� All wiring within this 4x4"
Junction Box is low voltage� It allows easy voltage testing to various oven components
for troubleshooting� All wiring harnesses and the Thermocouple are routed through
terminal strips within this box� Do not alter any wiring within this box or on the oven�
Under no circumstances is high voltage (120 VAC) wiring to be connected within this
box� No external equipment should be connected to the low voltage wiring of the oven�
This may affect the operation of the oven and will void the oven warranty� High voltage
connections are to be made only within the Transformer Junction Box�
Incoming power
must be 120 VAC. Do not connect to 240 VAC!
TRANSFORMER PLATE ASSEMBLY (AFTER MAY 2015)
The Transformer Plate is located beneath the oven on the back stand� It consists of one
of the two types of transformers within an 8x12" Junction Box� It allows easy voltage
testing to various oven components for troubleshooting� All wiring harnesses and the
Thermocouple are routed through terminal strips within this box�
Do not alter any wiring within this box or on the oven� No external equipment should
be connected to the low voltage wiring of the oven� This may affect the operation of
the oven and will void the oven warranty�
Incoming power must be 120 VAC when
configured with the Class 2 transformer. Do not connect to 240 VAC!
TOUCH-PAD CONTROLLER
On the front of the touch-pad Controller is a Lexan Keypad Overlay with a Hearth Temperature display, and depending on the oven
model, a Hearth Set Point display, and Dome Flame and Hearth Heat Indicator lights�
Also included on the touch-pad are On/Off, Farenheit/
Celsius and Up and Down adjustment arrows� Other than the
Controller Board, there are no other parts inside the box�
DIP SWITCH SETTINGS
The DIP switches on the Controller Board are preset at the
factory and are used to configure the board for the type of
oven: RFG-IR, W-IR or RFG� There should be no reason to
alter these settings in the field�
RFG-IR:
Both ON
W-IR: #1 OFF, #2 ON
RFG: Both OFF