Wood-mizer LT15 M2 E11S, Инструкция по безопасности, установке, эксплуатации и техническому обслуживанию, Страница: 68 / 100

Setup & Operation
Edging
3
3-23 15doc120709 Setup & Operation
10.
Repeat the steps used to cut the first side of the log until the log is square. Cut boards from the remaining
cant by adjusting the blade height for the thickness of boards that you want.
Example: Remember that the blade cuts a 1/16 - 1/8" (1.6 - 3.2 mm) wide kerf. If you want 1" (25 mm)
thick boards, lower the carriage 1 1/16 - 1 1/8" (27 - 29 mm) for each board.
3.12 Edging
The following steps guide you through edging boards on the Wood-Mizer sawmill.
1.
Raise the side supports to 1/2 the height of the flitches, or the boards that need to be edged.
2.
Stack the flitches on edge against the side supports.
3.
Clamp the flitches against the side supports halfway up the flitch height. (Wider flitches should be placed to
the clamp side. When they are edged, flip them over to edge the second side without disturbing the other
flitches or without having to pull them from the middle of the stack.)
4.
Adjust the blade height to edge a few of the widest boards.
5.
Loosen the clamps and turn the edged boards over to edge the other side.
6.
Repeat steps 2-4.
7.
Loosen the clamps and remove the boards that have good clean edges on both sides. Clamp the remaining
flitches and repeat steps 2-5.
3.13 Blade Height Scale
See Figure 3-4.
The blade height scale is mounted on the vertical mast. It includes:
„
a blade height indicator
„
centimeter scale (or quarter inch scale).
Blade Height Indicator
FIG. 3-4
150028C
Scale
Blade Height
Indicator