Wood-mizer LT15 M2 E11S, Инструкция по безопасности, установке, эксплуатации и техническому обслуживанию, Страница: 17 / 100

Safety & General Information
Engine/Motor Specifications
Safety & General Information 15doc120709 1-9
1
1.9 Engine/Motor Specifications
See Table 1-6.
The power options available for the LT15 sawmills are listed below.
See Table 1-7.
See the table below for power supply specifications for the LT15 sawmill.
DANGER!
It is recommended to use 30mA GFI (Ground Fault Interrupter).
1.10 Noise level
See Table 1-8.
The average level of noise is given in the table below
12
.
1.11 Dust Extractor Specifications
See Table 1-9.
See the table below for dust extractor specifications.
Engine/Motor Type Manufacturer Model No. Specifications
7.5 kW Motor Siemens, Germany 1LE1002 1CA13-4AA4-Z
F01+F12
3 x 400V, 50 Hz
13HP Gasoline Kohler CH13T Spec #PA22519
398 cm
3
10HP Diesel Yanmar, Japan L100
406 cm
3
, 3600
min
-1
Up/Down Motor
0.55kW
Besel SKh71X-4C2/HPS08 3x 230/400VAC, 50Hz
Power Feed Motor
0.55kW
Dutchi Motors,
Holland
DMA 80K4 230/400V, 50 Hz
TABLE 1-6
3-Phase V Switch, Fuse Recommended wire
section
400 VAC
16 A
2,5 mm
2
to 15m length
TABLE 1-7
Sawmill Noise level
LT15E11
L
EX8
= 81,9 dB (A)
TABLE 1-8
1. The noise level measurement was taken in accordance with PN-EN ISO 3746 Standard . The noise
exposure level given above concerns an 8-hour work day.
2. The measured values refer to emission levels, not necessarily to noise levels in the workplace. Although
there is a relation between emission levels and exposure levels, it is not possible to determine with certainty
if preventives are needed or are not needed. The factors affecting a current level of noise exposure during
work are inter alia room characteristics and characteristics of other noise sources, e.g. number of machines
and machining operations nearby. Also, the permissible exposure level value may vary depending on
country. This information enables the machine’s user to better identify hazards and a risk .