Wood-mizer LT15 M2 E11S, Инструкция по безопасности, установке, эксплуатации и техническому обслуживанию, Страница: 65 / 100

Setup & Operation
Feed Operation
Setup & Operation 15doc120709 3-20
3
CAUTION!
If at any time you need to immediately stop the blade motor,
press the emergency stop button located on the electric box.
3.10 Feed Operation
3.10.1 Standard Manual Feed System
The feed system includes a hand crank to move the carriage forward or backward. The speed at
which the carriage travels forward depends on how fast you turn the feed crank.
1.
To move the carriage forward, push the crank handle in to engage the screw heads and rotate the feed crank
clockwise.
See Figure 3-2.
HINT: To get a straight cut in the first part of the board, feed the blade into the log at a slow speed.
This stops the blade from flexing and dipping up or down. Use a slow speed until the whole width of
the blade has entered the cut. Then increase the feed rate as desired. Maximum feed rate varies with
width and hardness of the wood. Over-feeding results in blade and drive belt wear, and also
produces a wavy cut.
2.
To move the cutting head backward, rotate the feed crank counterclockwise, or pull the saw head back.
Always disengage the blade before returning the cutting head and raise the head slightly to make sure the
blade clears the log.
CAUTION!
Be sure to stop the blade when returning the cutting head. This
FIG. 3-2
150122B
Turn the crank clockwise
for forward feed;
counterclockwise to
return the saw head