Wood-mizer LT15 M2 E11S, Инструкция по безопасности, установке, эксплуатации и техническому обслуживанию, Страница: 48 / 100

Setup & Operation
Sawmill Setup
3
3-3 15doc120709 Setup & Operation
See Figure 3-1.
4.
Repeat the bed rail adjustment with the string at the other side of the sawmill frame.
5.
Install a blade (
See Section 3.2
through
Section 3.4
) and move the saw carriage until the blade is positioned
over the front bed rail.
6.
The blade guide rollers should not touch and deflect the blade and the blade guide arm should be adjusted
all the way out, away from the other blade guide.
7.
Measure the distance from the bed rail to the bottom of the blade near the inside (fixed) blade guide.
8.
Measure the distance from the bed rail to the bottom of the blade near the outside (movable) blade guide.
See Figure 3-2.
When the blade is parallel to the bed, it will measure the same distance from the bed rail at
the inside and outside of the saw head. To adjust the saw head tilt, loosen the four mounting bolts of the idle
side roller bracket, the two scraper mounting bolts and the two mounting bolts of the mast retaining bracket.
FIG. 3-1
String across
bed rails
Equal height
object
Equal height
object
Measure distance
between string
and bed rails
150115
Equal height
object
Measure distance
between string
and bed rails
Equal height
object
String Across
bed rails