Wood-mizer LT15 M2 E11S, Инструкция по безопасности, установке, эксплуатации и техническому обслуживанию, Страница: 47 / 100

Setup & Operation
Sawmill Setup
Setup & Operation 15doc120709 3-2
3
The LT15 sawmills are only partially aligned in factory. Some assemblies need to be aligned by a user
before first usage of the sawmill.
Assemblies aligned in factory:
„
Blade drive belt tension;
„
Engine rpm (DC only);
„
Blade wheels (in vertical and horizontal planes);
Assemblies NOT aligned in factory:
„
Blade guide arm alignment -
See Section 6.5
;
„
Blade guides -
See Section 6.6
;
„
Blade Height Scale -
See Section 6.12
;
„
Cam engaging the limit switch and/or stop bolt -
See page 3 - 8.
The following setup procedure should be performed whenever the sawmill is moved or reassembled.
If sawing problems occur and misalignment is suspected, see
SECTION 6 for complete alignment
instructions.
1.
Adjust the frame legs so the sawmill appears level. If sawmill is on soft ground, use shims under the legs if
necessary.
2.
Run a string from the front bed rail to the rear bed rail near the operator’s side of the frame. Place identical
spacers between the string and the front and rear bed rails. Measure the distance between the string and the
other bed rails. Adjust the frame legs until all bed rails measure the same distance from the string.
3.
Loosen the auxiliary bed rail bolts and adjust the rail so it is the same distance from the string as the main
bed rails. Retighten the bolts.