Current (basic) setting (factory setting):
auto
f
automatic night setback enabled
Pump runs in standard mode
not visible
f
Single pump
e.G.
H 5,0 m
f
present differential pressure setpoint
Hs = 5,0 m at same time
|
H
max
(factory setting depending on pump type)
f
Control system
∆
p-v
The differential pressure set point can be altered
by turning the tuning button. The new differential pres-
sure set point blinks.
The new setting is stored by pressing the button briefly.
If no button is pressed, the previously set blinking diffe-
rential pressure set point returns to the previous value af-
ter 30 s.
Press tuning button for > 1 s.
The next menu point
e
appears..
ENGLISH
36
If the pump display is operated further, the following menus appear in succession:
(horizontal representation of
display)
Single-pump mode: Setting when first used / Menu order during standard use
1
LC display
Setting
After switching on the module,
all symbols
appear on the display for 2
seconds. The current setting
w
then engages.
2
3
Position setting of display vertical / horizontal
The set position of the display is shown by the flashing "ON".
By turning the tuning button the other position can be
selected.
Setting stored.
If no setting is made in the subsequent menus for 30s, the basic setting
w
re-appears in the display..
Содержание Wilo-Stratos -Z
