Wilo Helix2.0-VE, Инструкция по установке и эксплуатации

Страница: 74 / 92

en
74 Installation and operating instructions • Drive for Wilo-Helix2.0-VE / Wilo-Medana CH3-LE • Ed.01/2022-06
Operating data
P act (Discharge) = 0.0 bar
n act = 0 /Min
P electr = 3 W
U mains = 0 V
P act Suction = 0.0 bar
Hydraulic operating data
• Actual delivery discharge pressure
• Actual delivery suction pressure
• Actual speed
Operating data
H act = 0.0 m
n act = 0 /Min
P electr = 6 W
U mains = 0 V
Electrical operating data
• Power consumption
• Mains voltage
NOTICE
The data given in this figure is dependent on the configured control mode.
P act value is given if a discharge pressure sensor (p-c) is in use. The p act
for a suction pressure sensor, if in use.
The H act value is given if a differential pressure sensor (dp-c, dp-v) is in use.
In the submenu “Statistics Data” the following information can be read:
Statistical data
W electr = 0 kWh
Operating hours = 8 h
Universal Displaytext
2.2 Measured values
2.2.2 Statistics data
Statistic data
• Absorbed energy summed up
• Operating hours
17 Reset
In this menu, the factory settings of the pump can be restored.
Factory setting
Back to factory settings
17.1 Factory setting
The pump can be reset to factory settings. In the “Reset” menu, select:
Reset to
factory setting
Confirm
(settings will be lost)
Cancel
Universal Display text
3.0 Factory setting
3.1 Restore factory setting
1. "Factory setting"
2. "Restore factory setting"
3. and "Confirm factory setting" in this sequence