widos 8000 WM SPA, Перевод инструкций по эксплуатации

Страница: 55 / 114

Welding process Chapter 6
09.06.15 Working Instructions WIDOS 8000 WM SPA page 55 of 108
6.2.3. Planing
Move the pipes on planer with <joystick 13> on: (cling to the joystick during
planing)
.
Display:
2nd line:
planing OK?
P0=0 Pi=14
Indication of:
moving force and upcoming force
Switch on planer with <joystick 6> on: simultaneously adjust planing pressure
with <pressure controller 15>; it should be appr. 10 - 20 bars + drag pressure; the
pressure is shown on the pressure gauge.
Carry out planing until a revolving chip is around the pipe ends 2-3 times with the
pipe ends being plane.
Interrupt planing in case too much chips have accumulated; for this purpose release
<joystick 6> and remove chips.
You can carry away cut injuries up to fractures! Do wear formfitting clothes, if necessary
wear a snood-type cap. Do not touch planer at the front surface.
The travelling area of the planer must be clear!
Noise exceeding 80 dB (A) may occur; during planing it is obligatory to wear ear protection!
Open pipe ends, <joystick 13> on: .
Deactivate planing, for this purpose release <joystick 6>.
Move the planer out of the machine, <joystick 6> on:
.
Remove the chips, thereby not touching the processed surfaces.
Confirm planing by pressing <Enter>.
Abort and back to basic menu by pressing <C>.
One menu step back by pressing <Enter> (keep pressed) and <->.
6.2.4. Compensation of mismatch
Close pipe ends, <joystick 13> on: .
Display:
2nd line:
alignment
T=210°C Pi=12
Display of:
heating element temperature and actual pressure
Release pressure, press <button 17, >.
Display:
2nd line:
alignment OK?
T=210°C Pi=12
Display of:
heating element temperature and actual pressure