WhisperGen PPS16-12MD, Руководство пользователя

Страница: 77 / 84

Trouble Shooting
Correcting Warnings
69
68 Engine sluggish Likely cause:
Low power output after cranking, possibly due to low gas pressure.
Recommended Action:
Attempt to restart. Contact an authorised WhisperGen
TM
service agent if the problem
reoccurs.
72 Drive bridge fail
Likely cause:
Abnormal electrical condition.
Recommended Action:
Attempt to restart. Contact an authorised WhisperGen
TM
service agent if the problem
reoccurs.
74 Low engine power
Likely cause:
Low power output, possibly due to low gas pressure. Low fuel flow.
Recommended Action:
Check fuel level, fuel valve, and fuel filter. Check exhaust for blockage. Flush heat
exchanger. Restart. If the problem reoccurs contact an authorised WhisperGen
TM
service agent.
76 O2 sensor OOL Likely cause:
Oxygen sensor reading out-of-limits, possibly resulting in poor combustion.
Recommended Action:
Check connector and restart. Replace oxygen sensor if fault continues.
80 Clamp failed on Likely cause:
Abnormal electrical condition.
Recommended Action:
Contact authorised WhisperGen
TM
service agent.
82 Excess volt drop Likely cause:
Too high electrical resistance between the WhisperGen
TM
and battery bank.
Recommended Action:
Check battery bank connections and battery bank voltage sensing wires. Restart.
Battery cables may be too small or too long. Check battery cable dimensions.
83 Battery overtemp
Likely cause:
Battery bank temperature too high for safe charging.
Recommended Action:
Check battery bank connections and ventilate battery bank compartment. Restart.
84 Clamp failed off Likely cause:
Abnormal electrical condition, possibly resulting in raised battery voltage.
Recommended Action:
Attempt to restart. Contact an authorised WhisperGen
TM
service agent if the problem
reoccurs.
85 High batt volts Likely cause:
Battery bank voltage above normal charging limits.
Recommended Action:
Check settings of any parallel charger connected to the battery bank. Restart.
90 Clamp control flt Likely cause:
WhisperGen
TM
unable to maintain correct battery charging voltage.
Recommended Action:
Attempt to restart. Contact an authorised WhisperGen
TM
service agent if the problem
reoccurs.
92 ParChg V too high Likely cause:
WhisperGen
TM
operating voltage has gone too high, in an effort to avoid conflict with a
parallel charger.
Recommended Action:
Check voltage settings of other chargers connected to the battery bank. Restart.
Correcting Warnings
Although a warning can be cleared without the physical cause being
removed, it is recommended that the cause be determined and removed at
the earliest opportunity. Warnings are indicated by a flashing
FAULT
indicator. No error message is displayed.
When remedying WhisperGen
TM
warnings, please follow the
recommendations in this manual. Otherwise you may injure yourself and
the warranty will be void. If the recommended action does not remedy the
warning then contact your authorised WhisperGen
TM
service agent.