Multi-Beam Safety Light Array
79
5.2.5.6.1 Access to the Memory Card
• The access to the memory card is located on the right side
of the control panel for the receiver (see Fig.).
• The slot can accept memory cards in microSD format.
• The memory card is protected by a screwed-on swivel cover.
• This cover can be loosened and screwed down again with a
screwdriver (Torx, size TX10).
• Permissible tightening torque: 0,4 Nm
• The swivel cover must be sealed correctly to guarantee the
IP degree of protection and to prevent the cover or the mem-
ory card from being lost.
• To remove the card, release the lock by pressing lightly on
the card, e.g. with a finger nail.
• When inserting the card in the slot, ensure that it engages
again.
5.2.5.6.2 Suitable Memory Cards
• Supported memory card types:
microSD
• Supported memory capacity:
max. 8 GB
• File system:
type FAT32
• The microSD card can be removed/replaced at any time (without impairing operation)
• Preferred type (wenglor order no.):
ZNNG013
5.2.5.6.3 File System
The following instructions must be followed to guarantee successful use of the microSD card:
• Every ESPE type has its own file with clear designation.
• The file name has the following structure: [Order number receiver].hex (e.g. SEFB612.hex]
• The designation must not be changed (e.g. SEFB612_V1.hex), as it can otherwise no longer be read in by
the ESPE.
• If a configuration is written on the memory card by the ESPE, an existing file with the same designation is
overwritten.
• The contents of the file itself can not be read and must not be changed.
• The ESPE can not search through folder structures. The desired file must therefore always be located on
the top level of the folder. Sub-folders may be created, but are not taken into account by the ESPE.
Figure 18: Access to the memory card on
the ESPE receiver
