Revised 8/2/2019
PFL2F53
Instruction Manual
CHARGING THE 18650 BATTERY
Warning: Never attempt to charge standard (non-rechargeable) batteries. Doing so could result in injury and
will void the warranty.
This unit operates on one rechargeable 18650 Li-Ion battery (included) and we recommend fully charging it first. To do
so, insert the battery into the home charger following the polarity diagram shown on the charger. Flip out the charging
plug on the back of the charger and plug it into a standard wall outlet.
Important: Do not charge for longer than 3 hours or continue to charge once the light on the charger turns
green. Once the light on the charger changes from red to green, the battery is fully charged and should be
removed from the charger.
INSTALLING THE BATTERY
1.
To access the battery compartment, unscrew the end cap (at the opposite end of the light) by turning it
counterclockwise.
2.
Insert the fully charged battery into the flashlight. The positive (+) end of the battery should be inserted first
(toward the head of the light). Screw the end cap back on by turning it clockwise.
USING THE FLASHLIGHT
1.
To turn on the light, press the rubber Push Button Tail Switch (located at the opposite end of the light) until it
clicks and the light turns on. This unit features five light modes: High, Medium, Low, Strobe and SOS.
2.
To change the light mode, “soft press” the rubber Push Button Tail Switch by applying light pressure (if you press
too hard it will click and turn off).
3.
To turn the flashlight off, “hard press” the rubber Push Button Tail Switch until it clicks.
Included Li-Ion Battery
Home Charger
(Flip Plug)
End Cap
Unscrew Here to Insert Battery
Push Button Tail Switch
(Not Shown)
