Wenglor SEFB Series, Руководство по эксплуатации, Страница: 145 / 161

Multi-Beam Safety Light Array 145
E 040 Receiver Permanent Ambient Light: Emitter of
the same type detected Remove the interfering
emitter
E 041 Receiver Permanent Ambient Light: Emitter of
the same type detected Remove the interfering
emitter
E 042 Receiver Permanent Ambient light: Potential
other cause Check for and remove
any other extraneous light
sources
E 043 Receiver Permanent Ambient light: Potential
other cause Check for and remove
any other extraneous light
sources
E 050 Emitter / receiver Permanent Parametrization not
complete Repeat parametrization
E 051 Emitter / receiver Permanent Parametrization not
complete Repeat parametrization
E 052 Receiver Permanent Safety Field:
• Monitored blanking
• Object too small
• Incorrect parameter
configuration
• Check blanking objects
• Repeat parametrization
E 053 Receiver Permanent Safety Field:
• Monitored blanking
• Object too small
• Incorrect parameter
configuration
• Check blanking objects
• Repeat parametrization
E 054 Receiver Permanent Safety Field:
• Monitored blanking
• Object too small
• Check blanking objects
• Repeat parametrization
E 055 Receiver Permanent Safety Field:
• Monitored blanking
• Object too small
• Check blanking objects
• Repeat parametrization
Internal errors
E 1xx
E 2xx Emitter /
receiver Permanent • Internal error • Disconnect the power
supply and restart the
ESPE.
• If this error occurs
repeatedly, contact
the wenglor support
department.
E126 Receiver Permanent • SD card present but file
is damaged
• Write SD card again
and insert and load in
ESPE
E127 Receiver Permanent • SD card present but file
is damaged
• Write SD card again
and insert and load in
ESPE