Welcat GTX-100, Руководство пользователя

Страница: 40 / 171

1-6 Charging Specification
1-17
1-6 Charging Specification
1-6-1 Charging the Battery Pack
GTX-100 allows charging with a battery pack installed on the terminal by using dedicated charger
(GTC-1/GTC-2). Though the operation can be performed in this status, but be sure to avoid the key operation
lest it may fall or cause poor contact with the charging terminal.
1-6-2 Charging Method using Single Charger (GTC-1)
When the GTX-100 and the battery pack are set at the same time, the GTX-100 charging has a priority. After the
GTX-100 charging completed, the battery pack charging starts.
The chargers can be connected by using the joint enclosed in the Single Charger (GTC-1). (Limited to single
Charger). However carrying them as connected gives a large load on the joint fixed part, take care in handling.
When more than four chargers are connected, please use the Multi Charger (GTC-2).
■Charging with the battery pack attached to the GTX-100
During charging, the SCAN LED on the GTX-100 will turn ON red, when charging completed turn
ON green. Charging time is approximately 2.5 hours.
Take notes to the direction of the GTX-100 when set it on the charger.
Place the GTX-100 in
the charger as shown
below.
During charging SCAN LED red turn ON,
Charging complete SCAN LED green turn ON,
Charging Error SCAN LED turn OFF,
In case an error occurred during charging in the
state of running on, the screen on the right will be
displayed for 5 seconds, and then the power will
turn OFF.
=%JCTIG#NGTV?
5JWVFQYP
%JCTIG'TTQT