Welcat GTX-100, Руководство пользователя

Страница: 31 / 171

Chapter 1 Hardware
1-8
Since setting the "1. SSID Setup" and "2. Security Setup" using the DHCP
client function creates a security weak point, please do not use this
function whenever possible.
■Bluetooth communication
Item Description Reference
pages
1. Terminal ID setup ID number for Identification to each GTX-100. "Blue-
Porter" and "WebGlider-X" identifies the terminal us-
ing this ID.
P.3-57
2. Bluetooth device setup The setup of registrations to connect required for com-
munication, and Security etc.
P.3-63
1-3-2 Data-Communication Method
Once the equipment has been setup, data communication can be performed using the following procedures.
■In the case of WLAN communications
The procedure for performing WLAN communications is as follows.
1. Connect the access point to the Ethernet LAN, then setup the access point so that it can communi-
cate with a host computer.
At this point, be sure to perform Security setup.
2. In order to enable the Security setup of 1. , Restart the access point. (Some access points do not re-
quire restarting.)
3. Turn ON the GTX-100 and setup the WLAN and TCP/IP from the System Menu. At this point, be
sure to perform Security setup.
When the GTX-100 is started up without Security setup, the warning screen "NO WLAN Security
" is displayed.
VQIGVUGVWR&Q
[QWYCPVVQUVCTV
OC[QEEWT$GUWTG
UGVWRPQY!
;'5 01
QH9.#0KUKPXCNKF
5GEWTKV[RTQDNGO
'PET[RVKQPU[UVGO
Though it is possible to make this warning screen being not displayed, this is not recommended for
Security reason. Please set this screen if there is no special reason for not displaying it.
4. From System menu, set up TCP/IP. (P.3-35)
5. When setup is complete, first perform the Ping test toward the IP address of the access point, then
toward the IP address of the computer.