Welcat GTX-100, Руководство пользователя

Страница: 100 / 171

3-10 Network Menu
3-45
●Supported Traps
Cold Start Cold Start Transmitted after MIB is initialized and the communications
starts. MIB is initialized when the GTX-100 has been turned ON using
the PW key. Note that MIB is not initialized when the GTX-100 has been
turned ON in the resume mode.
Warm Start Warm Start Transmitted when communication starts except Cold Start.
*1
Link up Link up Transmitted when GTX-100 synchronizes with an access point.
However, a Link Up is not transmitted when the GTX-100 synchronizes
with an access point for the first time (When a Cold Start or a Warm
Start is transmitted). When the GTX-100 newly enters a service area of
an access point and synchronizes, or when it synchronizes with a new
access point while roaming, a Link Up is transmitted (in the same timing
as signal SIGRFU_INSYNC).
Link down Link down Transmitted when the communication ends. However, it is
not transmitted when the GTX-100 is outside the service area of an ac-
cess point.
Authentication Transmitted when a third person tries to access the GTX-100 with an in-
valid community. This authentication trap is sent to the IP address set
through the System menu "Trap Manager IP address" (P.3-43). However,
this is transmitted only when the value "send" is set through the System
menu "Illegal access Trap" (P.3-44).
*1
MIB is not initialized even if the " GTX-100 " setup corresponding to MIB (IP address, subnet
mask, default gateway, etc.) has been changed. In this case, a Warm Start is transmitted instead
of a Cold Start. When initializing MIB, restart the terminal.