Weco Edge 550, Руководство пользователя

Страница: 47 / 221

Utilization... General principles of use
Edge 580 - Edge 550
3-46
3.2.2 C
ALLING UP A JOB
Two functions are available to open a job:
>
Press briefly on this button
When the numeric key pad is displayed, enter the job number and confirm it.
Résultat : the shape requested is displayed on the screen. The job number is displayed in the upper
tab of the shape display zone. The display is modified according to the job characteristics
and the default configuration values.
Exemple : If the lens material and finishing data are specified in the data given to the edger (e.g. :
CR39), they are displayed automatically.
>
Bar-code reading with hand held-scanner
Read your job's bar-codes with the hand-held bar-code scanner.
Résultat : the shape requested is displayed on the screen. The job number is displayed in the upper
tab of the shape display zone. The display is modified according to the job characteristics
and the default configuration values.
Exemple : If the lens material is specified in the data given to the edger (e.g. : Mineral), it is
automatically displayed and the screen is modified (with a mineral lens, only Bevel and Rim-
less finishing are accessible).
3.2.3 I
NSERTING
/ R
EMOVING THE LENS
3.2.3.1 T
O PLACE THE LENS IN THE EDGING CHAMBER
⇒
When all the job characteristics have been entered, insert the lens in the edging chamber.
⇒
Always check that the correct clamping adaptors for the job have been fitted.
If the job being run requires special adaptors, a warning message will be displayed automatically.
3.2.3.2 T
O REMOVE THE LENS FROM THE EDGING CHAMBER
When the edging cycle is stopped or interrupted, the visor opens.
⇒
Press briefly on this button .
Résultat : the lens clamp shaft opens automatically.
⇒
Remove the edged lens without removing the block so as to be able to retouch it if necessary.
19 mm diameter adaptors
25 mm diameter adaptors