Weco Edge 550, Руководство пользователя

Страница: 50 / 221

Utilization... General principles of use
Edge 580 - Edge 550
3-49
3.2.6 I
MPORTANT NOTES
3.2.6.1 W
HEN JOB DATA ARE RECEIVED
>
If the job provides the edging data, they are displayed automatically.
Exemple : If the job finishing is a bevel, the finishing displayed will automatically be Bevel.
>
If the job does not provide edging data, the default characteristics (see Configuration of finishing default pa-
rameters, chapter 4) will be displayed automatically.
Exemple : If the default finishing is Bevel and the type is Auto, the displayed finishing will be Bevel
and the sub-finishing Bevel Auto.
>
If you modify the job data before starting to edge one of the lenses, the new characteristics will be memorised
automatically and applied to the two lenses.
Attention ! Check the parameter values of the two lenses.
> The lens characteristics( material and type ) determine the types of finishing available.
Exemple : A mineral lens cannot be drilled. Drilling finishing is therefore not available in the finishings
pull-down menu when Mineral lens material is selected.
3.2.6.2 D
URING EDGING OF THE SECOND LENS
⇒
Always check that the preselected type of finishing is the finishing that you wish to apply.
In fact, the finishing selected for the first lens is automatically memorised and preselected for the
following lens (see “Edging several lenses identically”, page 83 and see “Edging the left lens with dif-
ferent parameters from those of the right lens”, page 82).
⇒
Check the parameter values.