Weco Edge 550, Руководство пользователя

Страница: 109 / 221

Configuration... Configuration of finishing default parameters
Edge 580 - Edge 550
4-108
4.2.1.3 A
CCESS
/E
XIT
4.2.1.3.1 T
O OPEN THE SCREEN
4.2.1.3.2 T
O QUIT THE SCREEN
4.2.2 S
TANDARD PROCEDURE
Follow the steps below to set the default value of a parameter :
Flow chart 4-1 : Setting a finishing parameter default value
4.2.3 S
AVING OF THE NEW SETTING
> When you leave the screen, the default values that you have selected are memorized automatically.
>
When you return to the standard application screen, you will see that the default values displayed are those
you have just entered.
4.2.4 L
IMITS
The information given in the tables below completes the values referred to in Using your Alta NX > Application
screen icons > Sub-finishings and associated parameters.
The default values that you wish to be memorised must be within the limits given by Briot. Any value outside the
interval shown cannot be validated.
The numeric key-pad will remain displayed until you have entered a correct value. If you wish to quit the numeric
key-pad, use the ESC key. The previous default value will then be applied again.
x 3
#1 Press the key-in button of the chosen parameter.
#2 Using the numeric key-pad, enter your chosen default value
within the limits displayed above the key-pad screen.
#3
#4 Continue in the same way for each default value that you wish to
change.