Weco Edge 550, Руководство пользователя

Страница: 192 / 221

Maintenance... Messages
Edge 580 - Edge 550
5-191
0x12 Incompatible edger
configuration
Drilling not allowed. The job you have loaded calls
for Drilling finishing.
In the personalisation menus,
you have excluded this
parameter, so the edger cannot
accept this job. Confirm the message.
If you wish to load this job
nonetheless, modifiy the
personalisation of the pull-down
menus.
Select Drilling finishing.
Load the job again.
0x13 Incompatible edger
configuration
Grooving / drilling not
allowed. The job you have loaded calls
for Grooving/Drilling finishing.
In the personalisation menus,
you have excluded this
parameter, so the edger cannot
accept this job. Confirm the message.
If you wish to load this job
nonetheless, modifiy the
personalisation of the pull-down
menus.
Select Grooving/Drilling
finishing.
Load the job again.
0x14 Incompatible edger
configuration
Bevel auto not allowed. The job you have loaded calls
for Automatic Bevel finishing.
In the personalisation menus,
you have excluded this
parameter, so the edger cannot
accept this job. Confirm the message.
If you wish to load this job
nonetheless, modifiy the
personalisation of the pull-down
menus.
Select Automatic Bevel finishing.
Load the job again.
0x15 Incompatible edger
configuration
Bevel curve not allowed. The job you have loaded calls
for Bevel curve finishing.
In the personalisation menus,
you have excluded this
parameter, so the edger cannot
accept this job. Confirm the message.
If you wish to load this job
nonetheless, modifiy the
personalisation of the pull-down
menus.
Select Bevel Curve finishing.
Load the job again.
0x16 Incompatible edger
configuration
Front bevel not allowed. The job you have loaded calls
for Front Bevel finishing.
In the personalisation menus,
you have excluded this
parameter, so the edger cannot
accept this job. Confirm the message.
If you wish to load this job
nonetheless, modifiy the
personalisation of the pull-down
menus.
Select Front Bevel finishing.
Load the job again.
0x17 Incompatible edger
configuration
Percent bevel not allowed. The job you have loaded calls
for Percentage Bevel finishing.
In the personalisation menus,
you have excluded this
parameter, so the edger cannot
accept this job. Confirm the message.
If you wish to load this job
nonetheless, modifiy the
personalisation of the pull-down
menus.
Select Percent Bevel finishing.
Load the job again.
0x18 Incompatible edger
configuration
Manuel bevel not allowed. The job you have loaded calls
for Manual Bevel finishing.
In the personalisation menus,
you have excluded this
parameter, so the edger cannot
accept this job. Confirm the message.
If you wish to load this job
nonetheless, modifiy the
personalisation of the pull-down
menus.
Select Manual Bevel finishing.
Load the job again.
# Message Conditions for display Action