Weco Edge 550, Руководство пользователя

Страница: 132 / 221

Maintenance... Regular maintenance of the edger
Edge 580 - Edge 550
5-131
5.4.2 C
HANGING THE MILL BIT
5.4.2.1 P
RELIMINARY REMARKS
It may be necessary to change the mill bit.
A change of mill bit may be necessary for the following reasons :
>
broken bit ;
> worn bit (chips around the holes on the internal side of the lens) ;
>
excessive use of the bit.
The machine is guaranteed to function correctly if Briot mill bits are mounted.
5.4.2.2 P
ROCEDURE
To change the mill bit, proceed as follows :
#1
#2
#3
#4
#5 Insert an Allen key or a screwdriver in the hole of the strut to block
the rotation of the spindle.
#6 Fit an 8 mm spanner on the chuck nut.
#7 Loosen the nut with one turn of the spanner, to free the bit.
#8 Use pliers to remove the bit from the chuck.
#9 Fit a new bit in the chuck. We advise you to apply a touch of grease
to the end of the bit to ease its insertion into the chuck. Attention !
Ensure that the bit is pushed home inside the chuck.
#10 Tighten the chuck nut lightly with the 8 mm spanner to fix the mill
bit.
#11 When the bit is tightened, remove the Allen key or the screwdriver.
#12
#13 Enter the bit diameter.