Weco Edge 550, Руководство пользователя

Страница: 195 / 221

Maintenance... Messages
Edge 580 - Edge 550
5-194
0x30 Do you want to save the
new GUI personalisation ? At least one of the parameters
of the menus personalisation
has changed. The machine
requests confirmation of this
modification. Confirm : the new
personalisation is registered.
No confirmation : the new
personalisation is not registered.
The previous personalisation is
retained.
Cancel : you return to the
personalisation screen for the
menu-button concerned.
Reselect the elements you wish
to display.
0x34 Groove too near front The distance between the front
face of the lens and the external
edge of the groove is less than
0.2 mm. Confirm the message.
Select Manual Groove sub-
finishing.
Visualize the position of the
groove on the control screen.
Reposition the groove.
0x35 Groove too far back The distance between the rear
face of the lens and the internal
edge of the groove is less than
0.2 mm. Confirm the message.
Select Manual Groove sub-
finishing.
Visualize the position of the
groove on the control screen.
Reposition the groove.
0x100 Requested job does not
exist. You have called up a job number
but the corresponding job is not
on the server. Call up another number
0x101 No response from server
wthin time limit. You have tried to load a job but
the edger has not received a
signal from the server. Check that :
. the server is switched on ;
. the OMA cord is correctly
connected to both terminals.
Then load the job again.
0x102 Server not connected. The OMA cable is unplugged.
OR
The server is switched off. Check that :
. the server is switched on ;
. the OMA cord is correctly
connected to both terminals.
Then, load the job again.
0x103 Corrupt OMA frame. The OMA frame sent by the
server displays a defect which
prevents reception. Contact a Briot technician.
0x104 Invalid OMA frame. The OMA frame sent by the
server displays characteristics
which the edger does not
recognize. Contact a Briot technician.
0x300 Touch screen not detected. When the edger is initialized, the
touch screen is not detected. Contact a Briot technician.
0x404 Safety-Bevel or Grooving
impossible. Safety-bevel and/or groove will
not be made because the lens
you wish to edge is either too
small or too thin to produce
safety-bevel or groove finishing. Confirm the message.
Select new parameters.
# Message Conditions for display Action