Programmable Carrier Signal Detection
, Which allows the Automatic Delay of Transmission while a
nearby Transmitter of the same Frequency is Operating.
Programmable Pager Database
,
Supporting 5,000+ pager
s, and up to 10 Groups of 20 Pager IDs each,
Stored in Non-Volatile EEPROM Memory. The Pager Database is “Not Required” for WaveWare Protocol,
Scope Protocol, Extended TAP Protocol, or Pager ID as Cap Code Mode.
Windows Software, called
WaveWare SPS-5 v
9
“Paging Encoder Setup”
is provided for Pager Database
Programming, Com Port Settings, Range Testing, and General Messaging.
Programmable Verbose or Non-Verbose Modes
, Verbose Output Means the Paging System Responses
Include more Information than Non-Verbose Responses.
Programmable Transmitter Duty Cycle Management
,
In Percentage
, from 0 to 100.
A Zero (0) value also means 100%.
Default
is 66% Duty Cycle.
Programmable Timed Messaging Function
,
Allowing the Paging System
to Monitor the Host System,
and Automatically Deliver Alert Paging Messages if the Host System does not communicate to the Paging
System within a Two Minute Time Cycle. The Timer Triggered Messaging Function can be Enabled or
Disabled via Programming, and can also be used as a Repetitive RF ping for Fully Supervised Applications.
Predefined Alert Messages can be up to 60 Characters in Length.
Programmable Maximum Batch Size for Batch Messaging
, Ranging from 1 to 32 Messages per Batch.
Batch Messaging allows Higher Message Throughput by Outputting a Single
POCSAG
Preamble for the
Batch of Messages.
Default
Max Batch Size is “10”
Programmable Pager ID as Cap Code Mode
,
This Mode
allows a Pager ID value in the COMP2 or TAP
Protocols to be treated as a Cap Code, allowing a Bypass of the Pager Database, and allowing Direct
Encoding of the Pager ID value as the Pager Cap Code. This Method Reduces Database Configuration
Efforts and Opens the Paging Encoder up to use of the Full Approximately 2 Million
POCSAG
Cap Code
Values.
Programmable Carrier Detect Polarity
,
Supports
Integration
of the WaveWare
v
9
Series Paging
Encoders
to a Variety of Radio Transmitters.
Choice of 0v or 5v
Default
is “0v”
Programmable Data Encoding Polarity
,
Supports
the Encoding of POCSAG Messages:
Normal Polarity
Inverted Polarity
Default
is “Normal”
Programmable Flow Control Signaling
,
Accommodates
a variety of methods of busy terminal signaling.
Choose either:
None
Hardware (CTS)
Software (XOFF/XON)
Alt Hardware (CTS gets asserted before message response)
Alt Software (XOFF is output before message response)
Default
is “Hardware”
The WaveWare
v
9
Series
“
Paging Encoders
” are used in the following product models:
SPS-5 v9
S
Paging System:
1
RS-232 DB-9 Female Serial com port, and 5 watt output, (2 watt Optional).
SPS-5 v9
Paging System:
2
RS-232 DB-9 Female Serial com ports, and 5 watt output, (2 watt Optional).
Encoder Only
version for
OEM
applications: Adjustable AC coupled and TTL radio Interface options.
“Introduction” Continues on the Next Page