WaveWare SPS v9S, Руководство пользователя

Страница: 11 / 57

PAGING SYSTEM INSTALLATION
Your WaveWare v 9 Series Paging Systems include: 1 Transmitter Unit, a “Rubber Duck” Antenna, 1 RS-232 Cable,
Mounting Screws/Plastic Anchor Kit and a Power Supply. A Second RS-232 Cable is available for Sale, if needed.
To install the paging system please following these steps:

Attach the “Rubber Duck” Antenna to the Transmitter Unit. In normal paging operations, the paging
transmitter antenna should be oriented in a vertical position to maximize the paging range.

Note: Do not attempt to operate the paging system without the antenna connected to the paging transmitter,
as damage to the paging transmitter may occur.

Remove the Front Cover of the Transmitter Unit. Hold the unit up against the wall or other non-metallic
vertical surface as a template to mark the 2 hole locations where you will mount the Transmitter Unit. Drill and
attach the top # 8 x ¾” sheet metal screw to the wall or vertical surface (use the plastic anchors if needed).
Mount the Transmitter Unit onto the top screw, using the 1 Slotted mounting hole near the top of the unit
inside the enclosure. Then attach the 2
nd
screw into the round hole near the bottom of the unit inside the
enclosure and tighten both screws. Re-attach the Front Cover of the Transmitter unit.

Plug the RS-232 Cable into an available DB9 serial port connector on the back of a Host Device , such as a
PC or Nurse Call system or other Host Device. If the serial port has a DB25 connector, you must provide a
DB25 to DB9 adapter, which is available from WaveWare or from a computer supply company. Tighten the
connector screws.

Plug the RS-232 Cable into the DB9 female connector on the Transmitter Unit. Tighten the connector screws.

Plug the Power Supply into a 110 VAC power outlet. The GREEN colored Power LED Indicator on the
Transmitter Unit should be illuminated when power is properly applied.

Program the pager database, if required, using WaveWare Paging v 9 Encoder Setup Software , which is
available from the WaveWare Product Support CD or from our Website , at
http://www.wirelessmessaging.com/wavewaresw.html

If you are using a PC as a Host Device, load paging control software, such as WaveWare Enterprise
Messaging Software, on the PC and configure it to operate with your WaveWare v 9 Series Paging System .
Make sure the proper serial port settings are defined. The GREEN colored RF TX LED Indicator on the
Transmitter Unit should illuminate for about 3-4 seconds during a normal paging transmission. If the Carrier
Detect function is enabled, you may see the
GREEN colored RF CD LED Indicator temporarily illuminate prior
to some paging transmissions, if a carrier signal is detected from a nearby transmitter at the same frequency
as your
WaveWare v 9 Series Paging System .
The “Quick Start Guide” is Next…