Element
Section 10: Edge SC Controller Operation
L-OMM-0003_A
• 10/8/2021 Technical Support • (800) 526-0288 • Mon-Fri, 8 am - 5 pm EST Page
69
of
157
Section III
–
Sub-System Details
10
EDGE SC CONTROLLER OPERATION
The information in this Chapter provides a guide to the operation of the Element using the Edge
SC Controller. Initial startup of this unit should only be performed by factory trained personnel.
Operation prior to initial startup by factory trained personnel will void the equipment warranty. In
addition, the following WARNINGS must be observed at all times.
W A R N I N G :
Do not attempt to dry-fire the unit. Starting the unit without a full water level can seriously
damage the unit, may result in injury to personnel or property and will void any warranty.
The unit must be serviced only by factory certified service technicians.
10.1 Edge SC Controller Description
The Edge SC Controller contains all the controls, indicators and displays necessary to operate,
adjust and troubleshoot the Element. The Edge SC Controller
’s capacitive touchscreen is a
highly sensitive device that continuously checks for user interaction at a very high frequency.
Mechanical room environments are sometimes harsh, electromagnetically noisy and dirty, and
can experience wide temperature ranges, and can be difficult for sensitive electronic
components. Care should be taken to not damage the touchscreen or get any grease or pipe
thread sealant on the touchscreen.
10.2 Welcome Screen and Navigation
Upon powering up, the Welcome screen appears with a
Sign In
prompt. This initial display
shows the
Tempered Supply
,
High Temp. Supply
,
Recirculation Inlet
and
Cold Water Inlet
temperature along with any applicable
Set Point
temperatures. Selecting any option will forward
the user to the Main Menu with each component displayed as outlined below.
Figure 48
– Welcome Screen
