Element
Operation and Maintenance
L-OMM-0003_A
• 10/8/2021 Technical Support • (800) 526-0288 • Mon-Fri, 8 am - 5 pm EST Page
112
of
157
In the event of a power cycle of Element, there is a potential risk of some of the configurations
specific to Element being reset, however this is typically due to a non-volatile memory (NVM)
error. Contact your Lync service representative if that error is given.
When powered up, the display will show a 100 second countdown timer and read:
NOTE:
The control will begin mixing operations automatically after 100 seconds. During that
time the user may adjust setting and configure the control by pressing the
PRGM
menu. If the
user does nothing, the control automatically routes to the home screen and begins normal
operation. Attempting to program the device at this time will reset the 100 second clock.
To program the system, press the
PRGM
button. The
Programming
screen appears.
12.2.1 To Create a Passcode:
DigiTemp Jr comes programmed with the default passcode
1017
. For added security, and to
help prevent unauthorized access, it is recommended that you create a unique 4 digit passcode
as outlined below.
On the Programming menu, press the
UNLOCK
icon. The Unlock function screen appears and
you are prompted to enter the passcode:
Creating your own passcode:
•
Enter the default passcode 1017 and press the Help icon.
•
Enter a new 4-digit passcode and press Enter (make sure to keep new code secure).
•
Re-enter the new passcode and press Enter again to finalize the passcode change.
NOTE:
If you make a mistake entering your passcode and it does not match,
????
appears.
