Element
Operation and Maintenance
L-OMM-0003_A
• 10/8/2021 Technical Support • (800) 526-0288 • Mon-Fri, 8 am - 5 pm EST Page
124
of
157
14
LYNC UV
The Lync UV
™ systems provides protection against microbiological contamination in water.
Disinfection of water with Lync UV is a simple, rapid physical process. When contaminated
water is exposed to a
SmartStream™ 254 nanometer UV light, the UV light penetrates the cell
walls of microorganisms and disrupts their genetic deoxyribonucleic acid (DNA) material. This
quickly inactivates microorganisms by destroying their ability to replicate and infect.
To install the Lync UV:
1. Install the quartz sleeve into the UV chamber.
DO NOT
touch the quartz sleeve with your
fingers. Hold it with a paper towel.
2. Install the quartz sleeve O-ring onto the visible end of the quartz sleeve. Screw the
quartz sleeve nut onto the quartz sleeve port thread and tighten hand tight.
3. Install the ultraviolet lamp into the quartz sleeve.
DO NOT
touch the lamp with your
fingers. Hold it with a paper towel.
4. Insert the lamp power lead wire into the receptacle on the lamp's glow cap.
W A R N I N G :
This appliance contains a UV-C emitter (UV lamp). Unintended use of the appliance or damage
to the housing may result in dangerous UV-C radiation escaping. UV-C radiation may, even in
small doses, can harm eyes and skin. Damaged appliances must not be operated. Do not
operate the UV-C emitter when it is removed from the appliance enclosure. The appliance
must be disconnected from the power supply before replacing the UV-C emitter. DO NOT look
directly at the UV-C emitter while it is on. Permanent serious eye injury could occur.
This device complies with part 15 of the FCC Rules. Operation is subject to the following two
conditions: (1) This device may not cause harmful interference, and (2) this device must accept
any interference received, including interference that may cause undesired operation.
This equipment complies with IC RSS-102 radiation exposure limits set forth for an uncontrolled
environment. This equipment should be installed and operated with minimum distance 20cm
between the radiator & your body.
The Watts UV
™ line of ultraviolet disinfection systems provide protection against
microbiological contamination in water for residential and commercial applications. Disinfection
of water with Lync UV
™ is a simple, rapid physical process. When contaminated water is
exposed to the Lync UV
's™ 254 nanometer UV light, the UV light penetrates the cell walls of
microorganisms and disrupts their genetic deoxyribonucleic acid (DNA) material. This quickly
inactivates microorganisms by destroying their ability to replicate and infect.
