Waterous Pressure Governor, Инструкция по установке и эксплуатации

Страница: 47 / 53

47
|
53
Safety Introduction Product Overview Installation Operation
Speed Mode
1 1
2 2
Use the illustrations and instructions to operate the
pressure governor in speed mode. Speed mode is
available when the Throttle Ready input is active,
and the Pump Engaged and OK To Pump inputs
are inactive, if the OK to pump setting is configured
to NORMAL. Or, when the OK To Pump input is
active and the OK to pump setting is configured to
OK2PUMP.
Configure the settings to adjust the parameters that
effect the speed mode. Refer to: "Configuring the
Pressure Governor" on page 35 .
Do not operate beyond
recommended pressure.
Liquid ejected at high
pressure can cause
serious injury.
High Pressure
•
•
The discharge pressure is not monitored
when operating in speed mode. Undesired
pressure buildup can occur, and result in
injury when safety protocols are not followed.
1 Press the RPM button to enable or disable
speed mode.
2 Rotate the knob or use the buttons to adjust
the engine speed.